Extraction Ventilator Schematics; Type And Seating Of Shaped Pieces Into Combustion Area - Atmos C15E Instruction Manual

Extraction ventilator schematics

CAUTION – The exhaust ventilator is provided disassembled. Assembler it on the smoke
duct, fasten properly and test its slow operation
1 - Motor
2 - Plate
3 - Rotating wheel (stainless steel)
4 - Nut with left-handed thread and washer
5 - Wing nut
6 - Screw
7 - Large gasket (2 pcs)
8 - Small gasket

4. Type and seating of shaped pieces into combustion area

1. For type
DC22S
DC25S
DC30SX
DC32S
DC50S
DC40SE
DC40SX
DC50SE
Roof of the lower combustion area must always be fully pressed against the boiler rear
wall.
10-GB
Instruction manual - GB
www.atmos.cz
27. Heatproof shaped piece –
roof is:
- for boilers (DC22S, DC25S,
DC30SX, DC32S,
DC40SX) length 500 mm;
- for boilers
DC50SE) length 700 mm.
DC40SE,
(DC50S,