Atmos Multi 24/80 User Operating Instructions Manual
Hide thumbs
Also See for Multi 24/80:
- Installation & servicing instructions manual (43 pages) ,
- Installation & servicing instructions manual (42 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Atmos Multi 24/80
Summary of Contents for Atmos Multi 24/80
- Page 1 Atmos Multi User Operating Instructions 24/80, 24/80 Plus, 32/80 Plus (GC 41-249-02, -03, -04) Atmos Heating Systems West March Daventry Northants, NN11 4SA Tel: 01327 871990 Fax: 01327 871905 e-mail: sales@atmos.uk.com internet: www.atmos.uk.com MK2 Revised (Side Pipe kit) 14.3.07 Amended 18.6.10...
- Page 3 Overview of Atmos Multi Boiler Components GAS/AIR MIXING CHAMBER CATCHMENT PLATE GAS INJECTION NOZZLE GAS VALVE AUTOMATIC AIR VENT CASING HIGH LIMIT THERMOSTAT IONISATION PROBE INLET CASTING IGNITION ELECTRODE IGNITION TRANSFORMER AIR SEPARATOR BURNER WATER HEATER VESSEL HEAT EXCHANGER FLUE GAS RESTRICTOR...
- Page 4 Overview of Atmos Multi Boiler with optional Pre-Assembled Pipework kit View with Pipework Assembly cover removed Pipework Assembly Components ATMOS MULTI Mk 2 version 2007 Page 4...
-
Page 5: Table Of Contents
Table of contents Introduction Congratulations... Overview of Atmos Multi components on the purchase of your new Atmos Multi. We are Overview of Atmos Multi with optional sure that it will give you many years of pleasure Pre-Assembled Pipework kit and comfort. We recommend that you read these... -
Page 6: How The Atmos Multi Works
• Closed design while after the heat demand has been met. The Atmos Multi is of the 'closed design' type. This means that a fan draws the air for the combustion The appliance will carry out a self-test when the... -
Page 7: The Control System
(and therefore the highest possible efficiency). • The operating panel The operating panel of the Atmos Multi is located on When central heating is demanded, the appliance the front of the control unit at the bottom centre of the always starts heating the home on a low burner heat appliance. -
Page 8: Hot Water On/Off Switch
Your installer the installer for installation and service activities. will be pleased to provide you with advice on this The Set button is protected against accidental use. subject. ATMOS MULTI Mk 2 version 2007 Page 8... -
Page 9: User's Program
• User’s program Table 2 shows the possible/ standard settings and The control unit of the Atmos Multi comes with an reports. inbuilt User’s program. This can be used to carry out the following:- Change the factory settings: • - hot water tank temperature (comfort setting 1, 2 or 3). -
Page 10: Filling, De-Aerating & Commissioning
The Atmos Multi does not have an integral central The following procedure should be followed when heating filling and drainage tap. Your installer will have filling the installation for the first time:-... -
Page 11: Starting The Water Heater
• Draining the central heating circuit 1. Switch off the electrical supply to the appliance. 2. Drain the installation via the drainage tap located at the lowest point of your central heating installation. ATMOS MULTI Mk 2 version 2007 Page 11... -
Page 12: Decommissioning The Appliance
A block is indicated by a constantly and recycling phases. The Atmos Multi is made of displayed letter on the diagnostic display. a number of primary materials, especially copper, aluminium and steel. -
Page 13: Information On Guarantee
The right to assess guarantee claims is reserved to Atmos, who must always be given This is an summary from the full Atmos the opportunity of inspecting the appliance on Warranty document which is available to site. - Page 14 Proof of guarantee This is your proof of guarantee. Please complete the enclosed Guarantee Registration Card and return it to Atmos within 14 days of installation (no stamp required) so that you will be entitled to make a claim on our service and guarantee, should a defect occur.