Spares - Atmos C15E Instruction Manual

Boilers do not reach their
required outputs and the pre-
set water temperatures
doors leaking
Ventilator does not turn

36. Spares

Heatproof shaped piece – nozzle heatproof shaped piece
Heatproof shaped piece
Ventilator
Switch with an indicator light
Thermometer
Control thermostat
Safety thermostat
Pump thermostat for DC15E
Waste gas thermostat
Door sealing cord 18 x 18
Door filling - Sibral
Condenser for draught ventilator UCJ4C52 - 1µF
Condenser for draught ventilator UCJ4C82 - 1,5µF
Condenser for compressing ventilator KORA - 3µF (DC70S)
Safety thermostat for 95°C pump (DC75SE)
Switching thermostat for 70°C pump (DC75SE)
Breaker
CAUTION – for boilers DC18S, DC22S, DC25S, DC20GS, DC22SX, DC25GS, DC30SE,
DC30SX use the draught ventilator UCJ4C52 with rotation wheel around Ø150 mm; for
boilers DC32GS, DC40GS, DC32S, DC50S, DC40SE, DC40SX use the draught ventila-
Instruction manual - GB
- insufficient chimney draught
- excessive chimney draught
- Bent blades of draught ven-
tilator - ignition too long or
boiler operated with the igni-
tion flap open
- insufficiently cleaned boiler
- combustion-air inlet to load-
ing chamber is clogged
- defective fibreglass cord
- the nozzle becomes clogged
- insufficient chimney draught
- boiler overheated – safety
thermostat fuse out
- rotating wheel clogged
- defective capacitor
- defective motor
- bad contact in plug of motor
cable lead
www.atmos.cz
- new chimney; unsuitable con-
nection
- place a throttle valve (draught
limiter) in the flue-gas duct
- pull the draught regulator
pulling rod out
- straighten blades (to a 90°
angle)
- replace
- clean
- clean
- replace
- adjust the door hinges
- do not burn small-particle
wood, sawdust, bark
- chimney defect
- press the thermostat push-but-
ton (using a pencil)
- clean the ventilator including
the ducting from tar and sedi-
ments
- replace
- replace
- check - measure
/5/
/10/, /11/, /12/, /13/, /23/
/4/
/20/
/18/
/24/
/36/
/40/
/35/
/26/
/25/
/29/
/29/
/29/
/7/
/28/
/37/
GB-33