Solving Malfunctions - Kyocera FS-C2026MFP Operation Manual

Solving Malfunctions

The table below provides general guidelines for problem solving.
If a problem occurs with your machine, look into the checkpoints and perform procedures indicated on the
following pages. If the problem persists, contact your Service Representative.
Symptom
The operation panel
does not respond
when the main power
switch is turned on.
Pressing the Start key
does not produce
copies.
Blank sheets are
ejected.
Faint or blurred
printing
Downloaded From ManualsPrinter.com Manuals
Checkpoints
Is the machine plugged in?
Is there a message on the
Message Display?
Is the machine in Sleep
mode?
Are the originals loaded
correctly?
—
Is the machine in Auto
Density mode?
Is the machine in Manual
Density mode?
Is the toner distributed evenly
within the toner container?
Is there a message indicating
the addition of toner?
Is the paper damp?
Is EcoPrint mode enabled?
—
Corrective Actions
Plug the power cord into an AC
outlet.
Determine appropriate response to
the message and respond
accordingly.
Press the Power key to recover
the machine from Sleep mode. The
machine will be ready to copy
within 20 seconds.
When placing originals on the
platen, place them face-down and
align them with the original size
indicator plates.
When placing originals in the
document processor, place them
face-up.
Check that the application software
is correctly operated.
Set the correct density level for
auto density.
Select the correct density level.
When changing the default density
level, adjust the density manually
and choose the desired level.
Shake the toner container from
side to side about several times.
Replace the toner container.
Replace the paper with new paper.
Disable EcoPrint mode.
Make sure the paper type setting is
correct the paper being used.
10-2
Troubleshooting
Reference
Page
—
—
2-9
2-44
2-46
—
—
5-16
—
9-4
9-4
2-26
4-10
8-13
8-15