Tcp/Ip (Ipv4) Setup; Tcp/Ip (Ipv6) Setup - Kyocera FS-C2026MFP Operation Manual

TCP/IP (IPv4) Setup

Set up TCP/IP to connect to the Windows network.
Refer to Network Setup (LAN Cable Connection) on page 2-14 about the procedures.

TCP/IP (IPv6) Setup

Set up TCP/IP (IPv6) to connect to the network. The default setting is Off.
Use the procedure below to setup the TCP/IP (IPv6) setting.
Downloaded From ManualsPrinter.com Manuals
Network Setting: a b
1 *TCP/IP Setting
*********************
NetWare
2
AppleTalk
3
LAN Interface:
1 *Auto
*********************
10Base-Half
2
10Base-Full
3
Sys. Menu/Count.:a b
Report
1
Counter
2
System
3
*********************
[ Exit
4
Press the OK key. The Network Setting menu
appears.
5
Press the
6
Press the OK key. LAN Interface appears.
a b
7
Press the
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
8
Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
1
In the Sys. Menu/Count. menu, press the
key to select [System], and press the OK key.
]
8-150
Default Setting (System Menu)
or key to select [LAN Interface].
or key to select the desired LAN
or