(2) Parameter verification
Whether same parameter values are set in other inverters or not can be checked.
Operation
1.
Replace the operation panel on the
inverter to be verified.
• Replace it during a stop.
2.
Screen at powering on
The monitor display appears.
3.
Press
to choose the parameter
setting mode.
4.
Turn
until
appears.
5.
Press
to read the currently set
value.
"
"(initial value) appears.
6.
Turn
to change it to the set value
" "(parameter copy verification mode).
7.
Press
to read the parameter setting
of the verified inverter to the operation panel.
• If different parameters exist, different
parameter numbers and
• Hold down
8.
It there is no difference,
flicker to complete verification.
REMARKS
When the copy destination inverter is not the FR-A700 series, "model error (
flickers ... Why?
Set frequencies, etc. may be different. Check set frequencies.
(parameter copy)
flicker.
to verify.
and
Flicker ··· Parameter verification complete!!
Operation panel (FR-DU07)
Display
The parameter
number read
previously appears.
Flickers for about 30s
Flickering
)" is displayed.
3
47