Konica Minolta bizhub c650 User Manual page 523

Utility mode
The Punch Unit Vertical Position screen appears.
6
Touch the button for the paper size to be adjusted.
If the paper size to be adjusted is not displayed, touch [↑] and [↓] until the desired paper size is
–
displayed.
7
Check the sample copy for the punch positions and for the center of the paper.
– If the punch positions are too far above the center of the paper, touch [+] under "Adjust Value" to
increase the adjustment (between 0.1 mm and 5.0 mm).
– Each time [+] or [-] is touched, the value is increased
or decreased by one increment.
– If the punch positions are too far blow the center of
the paper, touch [-] under "Adjust Value" to increase
the adjustment (between -0.1 mm and -5.0 mm).
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The vertical position of the punched holes is adjusted.
If no adjustment of the vertical position of the punched holes was necessary in step 7, this completes
the procedure.
9
Use a Punch setting to print another sample copy.
10
Check the print result.
– Check that the vertical position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
C650
11
11-62