[Alarm] Page - JVC VN-H557U Instructions Manual

[Alarm] Page

This page sets actions to be taken if an alarm
occurs. You can set up to five actions (No. 1 to No.
5).
This page can be used during access using
"admin" or "operator".
Click [Advanced Settings] in the side menu, and
0
click [Alarm].
Press the [OK] button to enable the new
0
settings. Only items that are valid under the
selected [Action] will be saved. If you set an
[Action] to "Disable", its settings are initialized.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
The contents displayed changes depending on
0
the selected action and the item of [1st Trigger].
Settings
* Setting values with R are default values.
No.1 to No.5
Action
Selects the action to perform when the alarm is
activated.
Disable:
0
Performs no action.
Mail:
0
Sends out e-mail. Specify the recipient's mail
address. The subject of the mail is "Alarm from
{model name}".
Enter the message to send in [Mail Text]. Enter
a message not longer than 127 characters.
To attach an image to the mail, set [JPEG
Attachment] to "ON".
TCP:
0
Sends the text string input in the [TCP Data] field
via TCP to the recipients specified in [TCP IP
Address] and [TCP Port Number].
UDP:
0
Sends the text string input in the [UDP Data] field
via UDP to the recipients specified in [UDP IP
Address] and [UDP Port Number].
Switch Scene File:
0
Specifies the filming scene.
Position:
0
Moves to the position set at [Action Position
Number].
(A p.41 [ Action Position Number ] )
Play Audio:
0
Plays back an audio file registered to the
camera.
For details about the audio file settings, refer to
[Audio File No.1 to No.5] on the [Audio] page.
(A p.38 [Audio File No.1 to No.5] )
Pin Output1 Make:
0
Changes Pin Output1 to Make.
Pin Output1 Break:
0
Changes Pin Output1 to Break.
Pin Output2 Make:
0
Changes Pin Output2 to Make.
Pin Output2 Break:
0
Changes Pin Output2 to Break.
[Set values: RDisable, Mail, TCP, UDP, Switch
Scene File, Position, Play Audio, Pin Output1
Make, Pin Output1 Break, Pin Output2 Make, Pin
Output2 Break]
[Advanced Settings] Page -[Alarm] Page
39