JVC VN-H557U Instructions Manual page 46

Settings
* Setting values with R are default values.
SD Card
SD Card
9 [Mount]/[Unmount] button
[Mount] button:
0
Click this button to mount a SD card to the
camera. After the SD card is mounted, you can
access it via the camera to perform operations
such as recording data to or playback back data
on the card.
When a SD card is mounted, this button
switches to the [Unmount] button display.
[Unmount] button:
0
Clicking this button stops recording if recording
to the SD card is in progress, and unmounts the
card from the camera. After the SD card is
unmounted, recording to or playback of data on
the card will not resume until the [Mount] button
is pressed again.
Memo :
When the power of the camera is turned on with
0
a SD card inserted, the card will be automatically
mounted to the camera.
If you do not want SD recording to start
0
automatically after powering off and on the
camera, or after clicking the [Mount] button, set
[Record Status] to "OFF" in advance.
Note :
Make sure to press the [Unmount] button before
0
turning off the power of the camera or removing
the SD card.
While writing to the SD card is in progress,
turning off the power or removing the card may
damage the data stored inside it.
[Advanced Settings] Page - [SD Card Recording] Page
46
9 Status
Displays the mount status of the SD card.
Mounted:
0
A SD card is mounted to the camera. Recording
to or playback of data on the card can be
performed.
Unmounted:
0
A SD card is not mounted to the camera.
Recording to and playback of data on the card
are disabled.
No card:
0
A SD card is not inserted into the camera, or the
inserted SD card cannot be recognized. To
enable recording to the SD card, insert a card
that can be recognized by the camera.
For details, refer to [Compatible SD
Cards] p.12.
Error:
0
Recording or playback cannot be performed
due to an error in the SD card.
SD Card Recording
Record Status
Starts/stops recording to the SD card.
Select "ON" and press the [OK] button to start
recording to the SD card.
Select "OFF" and press the [OK] button to stop
recording.
[Set values: ON, ROFF]
Memo :
This option is available only when [Status] of [SD
0
Card] is set to [Mounted].
Note :
If you want to change the time setting of the
0
camera using any of the following operations,
make sure that you stop SD card recording in
advance. Playback may fail if the time of the
video recorded in the SD card overlaps with the
time of the camera after changes are made.
When the time setting is changed in "PC Time
0
to Camera" on the [Basic Setting1] page.
(A p.28 [[Basic Setting1] Page] )
When the time setting is changed in "Time"
0
and "PC Time to Camera" on the [Time] page
under [Advanced Settings].
(A p.61 [[Time] Page] )
When the time setting is changed in "Time
0
Zone" on the [Time] page under [Advanced
Settings].
(A p.61 [[Time] Page] )