Connecting The Control Cables - ABB ACS580-04 Hardware Manual

80 Installation instructions

Connecting the control cables

1. Remove the middle front cover of the drive module.
2. Attach the option modules if not attached already. See section
modules on page 86.
3. Lead the control cables inside the drive cabinet.
4. Ground the outer control cable shields 360 degrees at the cabinet lead-through plate
(recommendation).
5. Route the control cables along the control cable duct from bottom or top to the control
unit.
1
2 × Combi screw
M4×8 Torx T20
2 N·m
3
5
Installing optional