Pnp Configuration For Digital Inputs (Digital In); Npn Configuration For Digital Inputs (Digital In); Connection For Obtaining 0 - ABB ACS580-04 Hardware Manual

84 Installation instructions

PNP configuration for digital inputs (DIGITAL IN)

Internal and external +24 V power supply connections for PNP configuration are shown in
the figure below.
Internal +24 V power supply
PNP connection (source)
10 +24V
11 DGND
12 DCOM
13 DI1
14 DI2
15 DI3
16 DI4
17 DI5
18 DI6

NPN configuration for digital inputs (DIGITAL IN)

Internal and external +24 V power supply connections for NPN configuration are shown in
the figure below.
Internal +24 V power supply
NPN connection (sink)
10 +24V
11 DGND
12 DCOM
13 DI1
14 DI2
15 DI3
16 DI4
17 DI5
18 DI6
Connection for obtaining 0...10 V from analog output 2 (ANALOG IN/OUT)
To obtain 0...10 V from analog output AO2, connect a 500 ohm resistor (or two 1 kohm
resistors in parallel) between the analog output 2 AO2 and analog common ground AGND.
Examples are shown in the figure below.
500 ohm
1 kohm 1 kohm
External +24 V power supply
PNP connection (source)
0 V DC
+24 V DC
External +24 V power supply
NPN connection (sink)
+24 V DC
0 V DC
8 AO2 Analog output 2. Default output 0...20 mA.
Analog common ground. Internally connected to chassis
9 AGND
through a 2 Mohm resistor.
8 AO2 Analog output 2. Default output 0...20 mA.
Analog common ground. Internally connected to chassis
9 AGND
through a 2 Mohm resistor.
10 +24V
11 DGND
12 DCOM
13 DI1
14 DI2
15 DI3
16 DI4
17 DI5
18 DI6
10 +24V
11 DGND
12 DCOM
13 DI1
14 DI2
15 DI3
16 DI4
17 DI5
18 DI6