Connecting the control cables
Connect the control cables as described below. Connect the conductors to the
appropriate detachable terminals of the RMIO board [see chapter
I/O board
Terminals
Location of terminals vary depending on the drive frame size.
Frame sizes R2 to R4
The control cable connection terminals are
exposed when the control panel mounting platform
is turned aside by pulling this knob. Be careful, do
not use excess force when pulling.
(control panel is an option)
Terminal for optional
Prevention of Unexpected
Start
I/O cables: Ground the
control cable shields in the
holes with screws. See
section
360 degrees
grounding.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
(RMIO)]. Tighten the screws to secure the connection.
Detachable connection terminals (pull up)
X39 for control panel cable
X41
Relay outputs
67
Motor control and
Optional module 1
Optional module 2
DDCS communication
option module 3:
RDCO
Place the warning
sticker here
Electrical installation