Electrical Installation; Warnings; Necessary Tools And Instructions; Terminal Designations - ABB ACS580-04 Hardware Manual

Electrical installation



Warnings

WARNING! Obey the instructions in chapter
ignore them, injury or death, or damage to the equipment can occur. If you are not
a qualified electrician, do not do electrical work.
Make sure that the drive is disconnected from the input power during installation. If
the drive is already connected to the input power, wait for 5 minutes after
disconnecting the input power.

Necessary tools and instructions

•
Screwdriver and a set of suitable bits
•
Cabling tools

Terminal designations

For more detailed information on the connectors, see section
Relay outputs
Marking
50 RO4C
51 RO4A
52 RO4B
53 RO5C
54 RO5A
55 RO5B
115/230 V inputs
Marking
70 HDI7
71 HDI8
72 NEUTRAL
73 HDI9
74 HDI10
75 NEUTRAL
76 HDI11
77 HDI12
78 NEUTRAL
1)
Neutral points 72, 75 and 78 are connected.

General cabling instructions

Obey the instructions given in chapter
page 51.

Wiring

Connect the external control cables to the applicable module terminals. Ground the outer
shield of the cables 360 degrees under a grounding clamp next to the control unit.
Description
Common, C
Normally closed, NC
Normally open, NO
Common, C
Normally closed, NC
Normally open, NO
Description
115/230 V input 1
115/230 V input 2
Neutral point
115/230 V input 3
115/230 V input 4
Neutral point
115/230 V input 5
115/230 V input 6
Neutral point
Guidelines for planning the electrical installation
Optional I/O extension modules 151
Safety instructions on page 13. If you
Technical data on page 160.
on