Multicast Forwarding - D-Link des-3010f User Manual

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual

Multicast Forwarding

The following figure and table describe how to set up Multicast Forwarding on the Switch. Open the Forwarding & Filtering
folder in the Administration menu, and click on the Multicast Forwarding link to see the entry screen below:
Figure 6- 54. Static Multicast Forwarding Settings and Current Multicast Forwarding Entries window
The Static Multicast Forwarding Settings page displays all of the entries made into the Switch's static multicast forwarding
table. Click the Add button to open the Setup Static Multicast Forwarding Table, as shown below:
The following parameters can be set:
Parameter
VID
Multicast MAC
Address
Port
Click Apply to implement the changes made. To delete an entry in the Static Multicast Forwarding Table, click the
corresponding under the Delete heading. Click the
Forwarding Settings window.
Figure 6- 55. Setup Static Multicast Forwarding Table
Description
The VLAN ID of the VLAN to which the corresponding MAC address belongs.
The MAC address of the static source of multicast packets. This must be a multicast MAC
address.
Allows the selection of ports that will be members of the static multicast group. The options
are:
None - No restrictions on the port dynamically joining the multicast group. When None is
chosen, the port will not be a member of the Static Multicast Group.
Egress - The port is a static member of the multicast group.
Show All Multicast Forwarding Entries
68
link to return to the Static Multicast