Figure 111 Service Menus-System/Network Setup Parameters Unit - Page 2 For The Board - Emerson Liebert CRV User Manual

Figure 111 Service menus—System/Network setup parameters Unit - Page 2 for the Board
S835 Monitoring Protocol—Selects the monitoring protocol. Velocity V4 is the factory default
which will provide communications to the Liebert IntelliSlot
units.
S836 IP Address—Contains the network address of the display. This address must be unique on the
network. This setting is used for the Liebert iCOM board and display connectivity and for a Liebert
iCOM U2U network. Do not use to configure remote monitoring.
S837 Netmask—Divides IP addresses in subnet and specifies the network available to hosts. This
setting is used for the Liebert iCOM board and display connectivity and for a Liebert iCOM U2U
network. Do not use to configure remote monitoring.
S838 Gateway— Routes data and acts as a proxy server or a firewall when setting up networks. This
setting is used for the Liebert iCOM board and display connectivity and for a Liebert iCOM U2U
network. Do not use to configure remote monitoring.
S839 MAC (Read Only)—The MAC address is a unique hardware identifier of the Ethernet device.
S840 U2U Protocol—This parameter is always set to GBP (Global Bus Protocol).
S841 U2U Address—This parameter is a unique identifier for each unit on the network. Display
addresses range from 1 to 32. Each display on the U2U network must have a different U2U address.
S842 U2U Group—Used to create zones or groups within a U2U network. Once a group number is
selected the display will see only devices with the same group number. The group number can be
changed to view devices in different groups.
S843 Bootloader Variables—Indicates whether the bootloader has been changed since it was last
loaded. This parameter should be activated only by an authorized service person.
S844 Static RAM—Shows the status of changes made and whether they have been saved to the
Static Memory on the board. The ranges of are:
• 0=Not Available
• 1=Invalid
• 2=OK
• 3=Changed
• 4=Updating
• 5=Locked.
The right hand paramter has two options:
• 0=nothing
• 1=Clear+Reboot. This clear all the settings in the Static RAM.
® housing. Hironet is used only on HPM
125
®
Liebert iCOM Control
® ™
Liebert CRV