Uncrating And Removing The Liebert Crv From The Skid-300Mm (12") Dx Units; Figure 11 Removing The Liebert Crv 300Mm (12") Dx Unit From The Skid - Emerson Liebert CRV User Manual

3.7 Uncrating and Removing the Liebert CRV from the Skid—300mm (12") DX Units
If possible, transport the unit using a forklift or pallet jack.
• If using a forklift or pallet jack, ensure that the fork tine length is suitable to safely move the
packaged unit.
• Emerson recommends keeping the unit on the shipping pallet and in its protective packaging
until it has been moved to its installation site.
• When handling and unpacking the unit, exercise great care to prevent damage.
• Do not lift the unit any higher than 6" (152mm) while moving it. If it must be lifted higher than
6" (152mm), exercise great care and keep all personnel who are not helping move the unit at least
20' (5m) away from the unit.
• The Liebert CRV 300mm (12") DX unit has four casters to permit rolling it into position. The unit
also has four outrigger-style stabilizer bars to help keep it from tipping.
WARNING
!
Risk of unsecured unit rolling off skid. Can cause equipment damage, injury or death.
The Liebert CRV 300mm (12") DX unit is on casters. Ensure that the unit/skid is located on a
flat surface before loosening the hardware securing the Liebert CRV to its shipping pallet.
1. Release the retaining clips along the seam in the corrugated packaging from around the unit. This
will allow removing the corrugated packaging (see Steps 1 and 2 in Figure 11).
2. Remove the two ramps, each is secured to the skid with two bolts with 1/4" hexagonal heads.
3. Fit the tab on each ramp into a hole on the shipping pallet as shown in (see the detail area in
Step 3 in Figure 11).
4. Remove the two shipping brackets, one on each side of the Liebert CRV. Each bracket is secured
by three bolts with a 9/16" hexagonal heads (see Step 4 in Figure 11).
At least two properly trained and qualified personnel may roll the Liebert CRV down the ramp and off
the pallet onto a flat surface.

Figure 11 Removing the Liebert CRV 300mm (12") DX unit from the skid

1
1/4" Hex Head
2 Per Ramp
® ™
Liebert CRV
Retaining Clip
3
9/16" Hex Head
3 Per Bracket
2
4
5
18
Inspection and Unpacking
315639P