Preparing The Liebert Crv For Installation; Figure 12 Adjust Leveling Feet-600Mm (24In.) And 300Mm (12In.) Units - Emerson Liebert CRV User Manual

4.0 P
REPARING THE
1. Open the display door and remove the lower front baffle panel using a 10mm nutdriver or T30
Torx Bit to prepare for installation.
2. Open the rear panel, referring to Figure 10. The documents are located inside the display door.
3. After the Liebert CRV is in its final installation position, adjust the four base supports, or feet,
with an adjustable wrench. Ensure that the unit is level to avoid corrosion or health hazards
caused by condensate accumulation.
a. Turning the base supports, or feet, clockwise, will extend them, lifting the unit one corner at a
time.
b. Tighten the nut on the top of each adjustable foot to lock the feet. The nut on 600mm (24in.)
units is inside the cabinet. The nut on 300mm (24in.) units is under the cabinet.
Figure 12 Adjust leveling feet—600mm (24in.) and 300mm (12in.) units
L CRV
IEBERT FOR

Preparing the Liebert CRV for Installation

I
NSTALLATION
Adjust the height of
the feet by turning
these with a wrench
Tighten this jam nut against the
cabinet floor after the foot is
adjusted to the desired height.
19
Tighten this nut after
the foot is adjusted to
the desired height
Adjust the height
of each foot
600mm (24in.) Unit
300mm (12in.) Unit
®
Liebert
™
CRV