Figure 128 Canbus Wire Cable With Grounding Wire - Emerson Liebert CRV User Manual

Figure 128 CANbus wire Cable with Grounding Wire

Solder
Ground Wire
Detail A
1
.25"
Pin 1
Black
}
1 1
Brown Pair 1
2
2
Blue
}
3 3
Pair 2
Violet
4 4
Yellow
}
5 5
Pair 3
Green
6
6
WIRE CONNECTION
Pin 1
1" Max.
This End Only
Black
1 1 }
Brown
2 2
Blue
}
3 3
Violet
4 4
Yellow
}
5 5
Green
6 6
WIRE CONNECTION
® ™
Liebert CRV
Heat Shrink
Drain Wire
5
2
Label:
1.5
7
"Sensor End"
Notes:
1. Length tolerances for each dimensioned segment are ± .25 up to 12.00, ± .50 for 12.00 to 24.00, and
above 24.00 is equal to ± 1.0.
2. Wire identification numbers or letters are hot stamped on each end of a wire.
3. Any wire not terminated into a terminal/connector is provided with a strip length of .50.
4. Assembly must be provided in accordance with latest revision of Emerson engineering specification 1A10952.
5. Information in parenthesis is not to be hot stamped.
6. Wire tie(s) and jumper(s) require no specific location(s). Wire ends align on left side unless otherwise specified.
7. Labels 3" from connection.
Label Including Liebert Part Number,
Manufacture date, Manufacturer Name
10-12" From Connector End Of Cable
7
Notes:
1. Length tolerances for each dimensioned segment are ± .25 up to 12.00, ± .50 for 12.00 to 24.00, and
above 24.00 is equal to ± 1.0.
Pair 1
2. Wire identification numbers or letters are hot stamped on each end of a wire.
3. Any wire not terminated into a terminal/connector is provided with a strip length of .50.
4. Assembly must be provided in accordance with latest revision of Emerson engineering specification 1A10952.
Pair 2
5. Information in parenthesis is not to be hot stamped.
6. Wire tie(s) and jumper(s) require no specific location(s). Wire ends align on left side unless otherwise specified.
7. Labels 3" from connection.
Pair 3
8. All agency information (UL andCSA), 300V rating, 75°C temperature rating, 24 AWG (3P), STP, <15pf/ft
capacitance and CMP labeled on cable.
3 4
A
6
3
4
Label:
7
"Unit End"
Length
(Depends on Part #)
Snag Proof/Molded
8
Protector
Typ (2) Ends
Ring Terminal for No. 8 Screw
4" Min.
Label:
7
"Unit End"
Length
(Depends on Part #)
146
Remote Rack Sensor Wiring
1. 2 5
5
1.5
181510
Pg. 1, Rev. 4
20 Gauge Insulated
Ground Wire
Ground Wire Soldered
Shrink Tubing
To Drain Wire, Covered
If Applicable
By Molding
1" to 1.75"
181510
Pg. 2, Rev. 4
1
Pin 1
.540
Pin 1