Table of Contents
Advertisement
LSQT1025(ENG).book 51 ページ ２００６年２月４日 土曜日 午後６時１０分
∫ About auto mode
Set the AUTO/MANUAL/FOCUS switch to AUTO,
and colour balance (white balance) and focusing will
be adjusted automatically.
– Auto white balance (l 161)
– Auto focusing (l 162)
Depending on the brightness of the subject etc., the
aperture and shutter speed are automatically
adjusted for an optimum brightness.
(When set to the disc recording mode: The shutter speed is adjusted to a maximum of 1/250.)
≥ Colour balance and focus may not be adjusted automatically depending on light sources or
scenes. If so, manually adjust these settings.
– Scene mode setting (l 75)
– White balance setting (l 78)
– Shutter speed setting (l 80)
– Iris/gain value setting (l 80)
– Focus setting (l 77)
∫ Anti-Ground-Shooting (AGS) (VDR-D300 only)
This function prevents unnecessary recording when you forget to pause
recording and walk with the unit tilted upside down while recording continues.
≥ If the unit continues to be tilted upside down from the normal horizontal
position while recording on a disc, it is automatically put into recording pause.
Turning the AGS function on/off
Rotate the mode dial to select
¬
Press the MENU button, then select [
[
AGS] # [ON] or [OFF] and press the joystick.
AGS
≥ The AGS function may activate and cause the unit
to pause the recording if you are recording a subject
right above or right below you. In these cases, set
[AGS] to [OFF] then continue the recording.
≥ Use the recording start/stop button to pause the
recording. The AGS function is only a backup
function for when you forget to pause the recording.
.
SETUP] #
≥ The time it takes the unit to be put into recording
pause after being tilted upside down varies
depending on the operating conditions.
Before recording
51
LSQT1025
Advertisement
Table of Contents
