Table of Contents
Advertisement
LSQT1025(ENG).book 159 ページ ２００６年２月４日 土曜日 午後６時１０分
About the SD card
≥ The memory capacity indicated on the label
of an SD card is the total of the capacity for
copyright protection and management and
the capacity which can be used on the unit, a
computer etc.
≥ During prolonged use, the unit's surfaces and
the SD card will heat up slightly. This is
normal.
When inserting or removing the SD card,
always set the OFF/ON switch to OFF.
While this unit accesses the SD card (while
or
is being displayed/the access
lamp is lit), do not remove the SD card,
operate the mode dial, turn off the power or
shake or impact the unit.
LCD monitor/viewfinder
≥ When the LCD monitor gets dirty, wipe it with
a dry soft cloth.
≥ In a place with drastic temperature changes,
condensation may form on the LCD monitor.
Wipe it with soft dry cloth.
≥ When the unit has become very cold, for
example due to storage in a cold area, its
LCD monitor will be slightly darker than usual
immediately after the power is turned on. The
normal brightness will be restored when the
unit's internal temperature rises.
Extremely high precision technology is
employed to produce the LCD Monitor
screen featuring a total of approximately
123,000 pixels. The result is more than
99.99% effective pixels with a mere 0.01% of
the pixels inactive or always lit. However, this
is not a malfunction and does not affect the
recorded picture.
Extremely high precision technology is
employed to produce the viewfinder screen
featuring a total of approximately 123,000
pixels. The result is more than 99.99%
effective pixels with a mere 0.01% of the
pixels inactive or always lit. However, this is
not a malfunction and does not affect the
recorded picture.
Cautions for use
159
LSQT1025
Advertisement
Table of Contents
