Table of Contents
Advertisement
LSQT1025(ENG).book 117 ページ ２００６年２月４日 土曜日 午後６時１０分
8 Select the layout setting on [
STANDARD: Layout specific to the printer
:
No frame print
:
Frame print
≥ You cannot set page layouts not supported on the printer.
PRINT] # [YES] and press the joystick.
9 Select [
The pictures are printed.
≥ Exit PictBridge by disconnecting the USB cable after the pictures
have been printed.
When you stop printing halfway
Move the joystick down.
A confirmation message appears. If [YES] is selected, the number of prints set is cancelled and the
screen returns to step 3. If [NO] is selected, all the settings are kept and the screen returns to
step 3.
≥ Avoid the following operations during printing.
These operations disable proper printing.
– Disconnecting the USB cable
– Removing the SD card
– Switching the mode dial
– Turning off the power
≥ Check the settings for the paper size, quality of
print, etc. on the printer.
≥ The sides of pictures recorded when [
(VDR-D300)/[
] (VDR-D250) is set may be cut
1.7
1.7
at printing. Check before printing.
When using the printer with a trimming feature or
other feature which cuts out both edges of the
pictures, cancel the feature for printing. (Refer to the
operating instructions of the printer for details.)
PAGE LAYOUT].
≥ You may not be able to print still pictures recorded
with other products.
≥ When the unit is connected directly to the printer,
the DPOF settings cannot be used.
≥ Connect the printer directly to this unit. Do not use a
USB hub.
]
2 2
With a printer (PictBridge)
117
LSQT1025
Advertisement
Table of Contents
