Table of Contents
Advertisement
LSQT1025(ENG).book 151 ページ ２００６年２月４日 土曜日 午後６時１０分
Problem
The screen has changed
suddenly.
The remote control does
not function.
The DISC EJECT lever
does not work.
The disc cannot be read.
A function indication
such as remaining time
indication or elapsed
time indication is not
shown.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
Check points
≥ Has the demonstration started?
# If you set [DEMO MODE] to [ON] without inserting a disc or a
card in disc recording mode or card recording mode, the unit
is automatically set to the demonstration mode for
introducing its functions. Normally this should be set to
[OFF]. Press the MENU button, then select [SETUP] #
[DEMO MODE] # [OFF] and press the joystick.
≥ Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 17)
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work when the unit is
connected to the computer. (l 155)
≥ Are there fingerprints or dirt on the surface of the disc?
# If there are fingerprints or dirt on the disc, wipe them off.
(l 24)
≥ If you set [SETUP]>[DISPLAY]>[OFF], indications other
than warnings and date indications disappear.
≥ Is the DVD-RAM or the DVD-RW (VR format) write-
protected?
# Release the protection. (l 108) If the DVD-RAM or DVD-
RW (VR format) was protected on another device, release
the protection on the same device.
≥ Has the DVD-RW (Video format) or DVD-R been finalized?
# After finalizing, the discs become play-only and cannot
record. If you un-finalize a DVD-RW (Video format), it can be
used for recording. (l 107)
≥ Has the SD card's write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set
to LOCK. (l 23)
≥ Is the memory of the disc or card full?
# If the disc or card has no more available memory, free up
some memory by deleting unnecessary scenes (l 87, 100)
or use a new disc or card.
≥ Is the unit set to the disc recording mode or card recording
mode?
# No recording is possible unless the mode dial is at
.
≥ Is the disc cover open?
# If the cover is open, this unit may not operate normally. Close
the disc cover.
Troubleshooting
or
151
LSQT1025
Advertisement
Table of Contents
