Table of Contents
Advertisement
LSQT1025(ENG).book 47 ページ ２００６年２月４日 土曜日 午後６時１０分
∫ Changing the date and time display style
Press the MENU button, then select [
TIME] # desired display style and press the joystick.
You can also show or change the date and time display by repeatedly
pressing the DATE/TIME button on the remote control.
[DATE]
[D/T]
15:30
15.12.2006
15.12.2006
≥ The recording time is not displayed in disc playback mode.
∫ Changing the display style
Press the MENU button, then select [
DATE FORMAT] # desired display style and press the
[
joystick.
Display style
15:30
Screen display
2006.12.15
≥ The date and time function are driven by a built-in
lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in lithium
battery has run down. Use the following steps to
charge the battery. When turn on the power for the
first time after charging, a message asking you to
set the date and time will appear. Select [YES] and
set the date and time.
To recharge the built-in lithium battery
Connect the AC adaptor or attach the battery to the
unit, and the built-in lithium battery will be
recharged. Leave this unit as is for approx.
24 hours, and the battery will save the date and
time for approx. 6 months. (Even if the OFF/ON
switch is set to OFF, the battery is still being
recharged.)
WARNING
THE LITHIUM BATTERY IN THIS UNIT MUST
ONLY BE REPLACED BY QUALIFIED
PERSONNEL. IF THIS IS NECESSARY,
CONTACT THE PANASONIC CUSTOMER
CARE CENTRE ON 132600 FOR YOUR
NEAREST AUTHORIZED SERVICE CENTRE.
SETUP] # [
[OFF]
SETUP] #
Y/M/D
M/D/Y
15:30
15:30
12.15.2006
15.12.2006
Setting date and time
DATE/
D/M/Y
47
LSQT1025
Advertisement
Table of Contents
