Table of Contents
Advertisement
LSQT1025(ENG).book 30 ページ ２００６年２月４日 土曜日 午後６時１０分
Power supply
How to turn off the power
While pressing the button A, set the OFF/ON switch to
OFF.
The status indicator B goes off when the power turns off.
≥ (VDR-D300 only) In disc recording mode or card recording mode, the lens
cover closes.
When the power is turned on for the first time after changing the disc or battery, the unit carries
out a recognition procedure to check that there are no problems with the disc.
This takes approximately 25 seconds with DVD-RAM.
If you want to start using the unit as soon as you turn on the power, do the following.
1) Turn on the power.
2) After "READING DISC..." disappears from the screen, turn off the power.
You can start recording approximately 8 seconds after you turn on the power again.
≥ Depending on the condition of the disc, it may take longer than this.
≥ If the date and time are not set, it will take longer than usual before you can start recording.
30
LSQT1025
A
B
Advertisement
Table of Contents
