Table of Contents
Advertisement
SOFTWARE
Client for Windows
Communication with ECUMASTER EMU device is performed using USB AA cable, and Microsoft
Windows based Client software. Client allows to modify all settings (parameters, tables) stored in
internal device flash memory as well as gathering real time data from engine sensors. Software is
available on CD included in the package. For the latest software please visit
www.ecumaster.com
web page.
Firmware
Firmware is internal EMU software that controls all aspects of device behavior. Due to the fact that
device firmware can be upgraded, in future there will be new device functions available. It is
required to use latest Client software with new firmware. The Client software is compatible
backwards, what means that all previous firmware will work correctly. However the old Client will
not work with new firmware (appropriate message will be shown). Firmware is always included
with Client software package and can be downloaded from www.ecumaster.com.
Software versions
Main software version is the first digit. The subversion is defined by 2 digits after the dot mark. The
third digit means that there are only changes in windows client software and there is no firmware
update. For example 1.01 means 1st main version with first software and firmware modification,
1.013 means first firmware update and fourth modification of Windows Client.
Software installation
Windows installation Client version is included on ECUMASTER CD or can be downloaded from
www.ecumaster.com. To install insert CD into drive and choose appropriate button or run
EmuSetup_xxx.exe. The software is compatible with the Windows XP, Vista and Windows 7 and
Windows 8. It might be also required to install USB drivers that are included on ECUMASTER CD.
If you have any problems with software installation, please contact our technical support at
tech@ecumaster.com.
Page 12
Advertisement
Table of Contents
Need help?
Do you have a question about the EMU and is the answer not in the manual?