Connecting To A Power Supply - Christie DWU1052 User Manual

Connecting to a power supply

1.
Insert the connector of the power cord into the AC (AC inlet) of the projector.
2.
Firmly plug the power cord's plug into the outlet. In a couple of seconds after
the power supply connection, the POWER indicator will light up in steady
orange.
When the DIRECT POWER ON function activated (83), the connection of the
power supply makes the projector turn on.
WARNING
unit is attached to it.
►Use extra caution when connecting the power cord, as incorrect or faulty
connections may result in fi re and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fi re, electric shock
or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE
• This product is also designed for IT power systems with a phase-to-
phase voltage of 220 to 240 V.
DWU1052/DHD1052
User's Manual - Operating Guide
Power cord
WARNING
►Do not use
tied power cord.
►Do not connect the projector to a power supply while no lens
21
Setting up
AC
020-000854-01 Rev. 1 (12-2015)
LIT MAN USR DWU/DHD1052