Adjusting the projector's elevator
Increasing or shortening the
length of the elevator feet shifts
the projection position and the
projection angle.
Turn the elevator feet each to
adjust their length.
max. 30 mm
WARNING
lengthened exceeding the limit may come off and drop the projector down, and
result in an injury or damaging the projector.
CAUTION
5 degrees. The projector leaned exceeding the limit could cause malfunction and
shorten the life of the projector.
Installation angle
10°
10°
10° 10°
DWU1052/DHD1052
User's Manual - Operating Guide
►Do not lengthen the elevator feet exceeding 30 mm. The foot
►Do not place the projector with an inclination exceeding
Terminal side
Vertical and horizontal direction in
portrait mode
The projector may be installed at
horizontal angle of ±10°.
The projector may be installed at
vertical angle of ±10°.
NOTE
projector must face upward for
vertical installations.
• If other error has occurred, check
installation. Install the projector
correctly, and restart it.
• When using portrait mode, the
service life of a lamp becomes
shorter.
33
Operating
• The terminal side of the
020-000854-01 Rev. 1 (12-2015)
LIT MAN USR DWU/DHD1052
5°