Maintenance; Replacing The Lamp - Christie DWU1052 User Manual

Maintenance

Maintenance

Replacing the lamp

A lamp has finite product life. Using the lamp for long periods of time could cause
the pictures darker or the color tone poor. Each lamp has a different lifetime, and
some may burst or burn out soon after you start using them.
New lamp preparation and early replacement are recommended. To prepare a
new lamp, contact your dealer and indicate the lamp type number.
Type number : 003-005516-01（DT01915）
1.
Turn the projector off, and unplug the power cord. Allow the projector to cool
for at least 20 minutes.
2.
Prepare a new lamp. If the projector is mounted with specified mounting
accessories, or if the lamp has broken, also ask the dealer to replace the lamp.
In case of replacement by yourself, follow the following procedure.
3.
Loosen the screw (marked by arrow) of the lamp cover and then slide down
and lift the lamp cover to remove it. The lamp cover is tied to a short wire to
prevent from falling.
3
Lamp cover
(4)
(LAMP2)
(continued on next page)
DWU1052/DHD1052
User's Manual - Operating Guide
Lamp cover
(4)
(LAMP1)
102 020-000854-01 Rev. 1 (12-2015)
LIT MAN USR DWU/DHD1052