Checking Your Own Number - Foma P906i Instruction Manual

2
i(
)1Notify caller ID
1Don't notify or Notify caller (OFF or ON)
≥To release "Notify caller ID", select "Cancel prefix". Whether to notify or not
follows the setting for "Activate" of "Caller ID notification".
Set "Notify/Not Notify" by Entering "186/184"
You can select whether to notify the other party of your phone number
also by entering "186"/"184" before the other party's phone number.
To notify your caller ID
1
186→Destination phone number1d or
≥Press l(
) to make a videophone call.
Not to notify your caller ID
1
184→Destination phone number1d or
≥Press l(
) to make a videophone call.
Information
≥When you make a call and hear the guidance requesting your caller ID (see
page 452), follow the steps of "To notify your caller ID" to enter "186" and redial.
≥When you make a PushTalk call, "Activate" of "Caller ID notification" or "Notify caller
ID" is valid, but "notify/not notify" by adding "186"/ "184" is invalid.
≥You cannot set "Caller ID notification" while "
48
o ( O
)
o ( O
)
" is displayed.
<Own Number>

Checking Your Own Number

≥Your phone number (own number) is stored on the UIM.
1
m1Phonebook1Own number
o to switch the tabs. N
You can press
≥See page 417 for storing/displaying personal data.
Information
≥In Dual Mode of 2in1, you can switch between Number A and Number B by pressing
O o ( +
) from the Own Number display. "
appears for Number B.
≥When you replace a UIM with another one (2in1 contractor → 2in1 contractor) while
using 2in1, perform "2in1 function OFF" (see page 457) and then set "2in1 setting" to
"YES", or perform "Auto acquire No. B" (see page 418), to acquire the correct Number
B.
When you replace a UIM with another one (2in1 contractor → 2in1 non-contractor),
perform "2in1 function OFF" as well to update the owner's information to the correct
one.
m + 0 -
List tab
Phone number tab
Own Number display
" appears for Number A, and " "