Before Using Data Communication - Foma P906i Instruction Manual

Before Using Data Communication

Charge of Internet service provider
To use the Internet, you need to pay the charge for the Internet service provider
you use. Besides the FOMA service fee, you need to directly pay this charge to the
Internet service provider. For details on the charge, contact the Internet service
provider you use.
You can use the DoCoMo Internet access service, "mopera U"/ "mopera".
To use "mopera U", subscription (charged) is required. To use "mopera",
subscription and monthly charge are not required. However, the maximum
communication speed of sending/receiving data is limited to 384 kbps.
Setting access point (Internet service provider, etc.)
The access points for the packet communication and 64K data communication
differ. To use the packet communication, connect to an access point which
supports packet communication. To use the 64K data communication, connect to
an access point which supports FOMA 64K data communication or
ISDN-synchronous 64K.
≥You cannot connect to the DoPa access point.
About user authentication for accessing network
User authentication (ID and password) may be required at connection to some
access points. In this case, enter your ID and password on the communication
software program (dial-up network). ID and password are specified by the Internet
service provider or network administrator of the access point. For details, contact
the provider or network administrator.
About access authentication for using browser
If you need FirstPass (user certificate), install the FirstPass PC software from the
provided CD-ROM and make the setting.
For details, refer to "FirstPassManual" (PDF format) in the "FirstPassPCSoft"
®
folder on the CD-ROM. Adobe Reader
required to see "FirstPassManual" (PDF format). If it is not installed in your
®
personal computer, install Adobe Reader
For details such as how to use it, refer to "Adobe Reader Help".
Conditions of packet communication and 64K data
communication
To carry out the communication by using the FOMA phone in Japan, the following
conditions are required:
≥The personal computer to be used can use the FOMA USB Cable with Charge
Function 01/02 (option).
≥When connecting using Bluetooth communication, the personal computer should
support Dial-up Networking Profile of Bluetooth Specification Ver. 1.1, Ver. 1.2, or Ver.
2.0+EDR.
≥The PDA to be used should support FOMA packet communication and 64K data
communication.
≥Within the FOMA service area
≥For packet communication, the access point should support packet communication of
the FOMA.
≥For 64K data communication, the access point should support the FOMA 64K data
communication or ISDN-synchronous 64K.
Even when these conditions are satisfied, if the base station is congested or the
radio wave conditions are bad, you may not carry out the communication.
®
(version 6.0 or higher is recommended) is
®
from the provided CD-ROM to see it.
467