Automatically Clearing Settings (System Auto Reset); Automatically Conserving Energy (Low Power Mode); Automatically Conserving Energy (Sleep Mode) - Konica Minolta Bizhub C353P User Manual

Before using the machine
Do not turn off the machine with the power switch while it is making printing, otherwise a paper misfeed
may occur.
Do not turn off the machine with the power switch while a queued job or stored data is waiting to be
printed, otherwise the jobs will be deleted.
!
Detail
The following are cleared when the power switch is turned off.
Settings that have not been programmed
Jobs queued to be printed.
1.2.3

Automatically clearing settings (System Auto Reset)

If no operation is performed for a specified length of time while settings are being changed, settings that have
not been programmed are cleared and return to their defaults.
This is the system auto reset operation.
As the factory default, the system auto reset operation is performed after 1 minute.
!
Detail
The length of time until the system auto reset operation is performed and whether or not it is performed
can be set from "System Setting" menu. For details, refer to
1.2.4

Automatically conserving energy (Low Power mode)

If no operation is performed for a specified length of time the machine automatically enters a mode where it
conserves energy.
This is the Low Power mode.
The machine can receive jobs even while it is in Low Power mode.
As the factory default, the machine enters Low Power mode after 15 minutes.
Note
When a print job is received, the machine recovers from Low Power mode and begins printing after it
has finished warming up.
The Low Power mode can also be canceled by pressing any key in the control panel.
!
Detail
The length of time until the machine enters Low Power mode can be changed. For details, refer to
"System Settings" on page
1.2.5

Automatically conserving energy (Sleep mode)

If no operation is performed for a specified length of time, the machine automatically enters a mode where it
conserves energy.
This is the Sleep mode.
Although the machine conserves more energy in Sleep mode than in Low Power mode, the machine must
warm up when Sleep mode is canceled to begin printing again, therefore taking more preparation time than
Low Power mode.
As the factory default, the machine enters Sleep mode after 20 minutes.
Note
When a print job is received, the machine recovers from Low Power mode and begins printing after it
has finished warming up.
The Sleep mode can also be canceled by pressing any key in the control panel.
C353P
8-18.
"System Settings" on page
1
8-21.
1-16