Ethernet Connection - Xerox Phaser EX7750 Configuration Manual

1
1-12 Connecting to the Network

Ethernet connection

For Ethernet connections, the EX7750 supports Unshielded Twisted Pair (UTP,
4 pairs) cabling, defined as Category 5 for use with 100BaseT and 1000BaseT; or as
Category 3, Category 4, or Category 5 for use with 10BaseT. The cable uses an 8-pin
RJ-45 connector that plugs into the RJ-45 socket on the EX7750.
The 100BaseT and 1000BaseT types supported by the EX7750 are 100BaseTX
N :
OTE
and 1000BaseTX, respectively, also known as Fast Ethernet. If an Ethernet hub is used,
it must be a 100BaseTX or 1000BaseTX hub. The term "100BaseT" and
"1000BaseT" are used to refer to 100BaseTX and 1000BaseTX, respectively.
T N
O CONNECT TO THE ETWORK CONNECTOR
• Connect the network cable to the RJ-45 connector on the back of the EX7750.
Make sure to connect the network cable to the connector marked LAN on the
N :
OTE
back of the EX7750. The connector marked with the copier illustration is used for the
connection to the printer. See the illustration on
You must use a Category 5 unshielded twisted pair network cable for 100BaseT and
1000BaseT.
page 1-11.