Postscript Setup Options - Xerox Phaser EX7750 Configuration Manual

4
4-46 Performing Setup from the Control Panel

PostScript Setup options

PS (PostScript) Setup allows you to set defaults for the EX7750. Users can override
most of these defaults on a job-by-job basis. However, users printing from UNIX or
DOS command lines cannot override defaults from their applications. Therefore, you
must set defaults in PS Setup. For information about these defaults, see the
Guide.
T PS S
O ACCESS ETUP OPTIONS
1. In the main Setup menu, choose PS Setup.
2. Enter the options appropriate to the printing requirements at the site.
3. When you finish, save changes.
In the list of options that follows, default values, where applicable, appear in
square brackets.
Print Master
Yes/No [Yes]
Specify whether to print a master document when it is created using FreeForm. If you
select Yes, when a user creates a master document, it is Ripped, held in the EX7750
Hold queue, and printed for your reference. If you select No, the master document is
only Ripped and held in the Hold queue.
Convert Paper Sizes
No 8.5x11/11x17->A4/A3 A4/A3->8.5x11/11x17 [No]
Specify whether to convert paper sizes in documents automatically to the default paper
sizes specified in the printer. For example, if you select 8.5
size document is automatically printed on A4 paper.
Color Mode
CMYK/Grayscale [CMYK]
Specify whether to print color (CMYK) or Grayscale images to the EX7750 by default.
CMYK gives you full color prints. Select CMYK as the Color Mode before performing
calibration on the EX7750. Grayscale converts all colors into shades of gray.
Printing
x 11/11 x 17->A4/A3, a letter