Prepare To Set Up The Ex/I Print Server; Ethernet Connection - Xerox EX 570 Configuration And Setup

S
YSTEM

Prepare to set up the EX/i Print Server

To prepare for printing at your site, you must do some initial EX/i Print Server configuration
(or "Setup") to specify the network environment and the types of printing you do. Before you
perform Setup, decide the levels of access to implement, such as passwords and other security
features that the EX/i Print Server offers. Because many of these security features are
interconnected, review the information to plan for an effective security system, and then
perform Setup accordingly.

Ethernet connection

For Ethernet connections, the EX/i Print Server supports Unshielded Twisted Pair (UTP)
cabling for these network speeds:
• 10BaseT: Category 3 or later
• 100BaseTX: Category 5 or later (4-pair/8-wire, short-length)
• 1000BaseT: Category 5e or later (4-pair/8-wire, short-length)
T
O CONNECT TO THE NETWORK
1 Power off the printer and the EX/i Print Server (see
2 Connect the cable from the network to the network connector (RJ-45) on the EX/i Print
Server (see
If you are concerned about information being extracted from the EX/i Print Server Ethernet
port without authorization, consider securing the Ethernet port.
3 Power on the EX/i Print Server and the printer.
On the EX/i Print Server, move the power switch to the ON position and then press the
power button (see
R
EQUIREMENTS
page 19 and page 20).
page 18).
page 42).
21