Xerox Phaser EX7750 Configuration Manual page 48

3
3-2 Preparing for EX7750 Setup
In addition, you can enable the Printed queue, which is a storage area for the most
recent jobs from the Print queue. The Printed queue makes it convenient to reprint
those jobs. In Setup, you can enable the Printed queue and specify the maximum
number of jobs retained in the queue (see
page 4-15). Reprinting jobs in the Printed queue requires the job management tools.
To use the Fiery utilities and WebTools, you must enable at least one of the
print connections.
Hold queue
Jobs sent to the Hold queue are spooled to the EX7750 hard disk for printing at a later
time or for reprinting. Because the Hold queue is a storage place, jobs sent to it cannot
proceed through the printing process until the operator intervenes using the job
management tools (see the
Print queue
This is the standard EX7750 queue. Jobs sent to the Print queue are processed and
printed in the order they are received. Jobs prioritized by an operator with the job
management tools and jobs sent via the Direct connection take priority over jobs sent
to the Print queue.
Direct connection
The Direct connection transmits jobs directly to the EX7750, but only when the
EX7750 is Idle. If the EX7750 is busy, the job remains at the user workstation until
the EX7750 is ready. The job is then processed as soon as the previous job is finished
and before the next queued job is processed.
Jobs sent to the Direct connection are not stored on the EX7750 hard disk, and cannot
be selected for reprinting, moving, or deletion. Jobs sent to the Direct connection do
appear in the Job Log, for accounting purposes.
To download fonts to the EX7750, you must publish the Direct connection.
N :
OTE
The Direct connection is not supported for LPR printing.
N :
OTE
"Jobs Saved in Printed Queue 1-99 [10]"
Job Management Guide).
on