Xerox Phaser EX7750 Configuration Manual page 185

7
7-11 System software
3. Insert the appropriate language CD 1 in the DVD drive.
If you installed a new HDD, you need to power on the system using the power
N :
OTE
switch on the back panel, insert CD 1, and allow the system to boot from the CD, and
then proceed to step 6 on page 7-11.
4. Choose Shut Down from the Functions menu (see
5. At the next screen, select Reboot System.
Allow the system to shut down and reboot. Do not push any buttons during this time.
6. When the following screen appears, make sure "Yes" is displayed, and then select OK.
The installation process begins immediately.
All data will be
deleted. Continue?
Yes
Install XPe
Wait while the Control Panel displays screens indicating that the operating system
software is being installed. This segment takes approximately five minutes.
7. At the message "To complete installation, insert CD 2 and recycle power," remove CD 1
and insert CD 2. Then, using the power switch on the back panel, power off the
system, wait 10 seconds, and then power the system back on.
After you power the system back on, the Control Panel displays screens indicating that
the system software is being installed. The system also creates a backup of the system
software during this segment. Allow installation to proceed without interruption. This
segment takes approximately 15 minutes.
8. At the message "Remove CD and recycle power," remove CD 2. Then, using the power
switch on the back panel, power off the system, wait 10 seconds, and then power the
system back on.
After you power on, the EX7750 organizes the software on the system and then
reboots once (twice, if the FACI option is enabled). This segment takes approximately
10 minutes.
9. At the message "Please insert CD 3", insert CD 3, and then close the drive drawer.
CD 3 installs automatically. Installation takes approximately one minute.
OK Select
page 7-24).