Assembly - Fire Sense PH03-S Manual

ASSEMblY

13
Install Reflector. NOTE: MAKE SURE TO REMOvE THE blUE
REFlECTOR TAPE ON REFlECTOR PIECES PRIOR
TO ASSEMblY! Assembly Tip: If necessary for proper alignment of
reflector sections, loosen each screw prior to further assembly and
retighten after sections are aligned. Slide two Reflector Panels
together. Insert one Small Screw
screw on Cap Nut from top. Repeat with the other Reflector
Panels . Slide Reflector Center Cap
Panels. Insert one Small Screw and screw on Cap Nut loosely.
Repeat with two more Small Screws and Cap Nuts to complete
reflector assembly. Fully tighten all screws and cap nuts.
Hardware Used: 9x Small Screw | 9x Cap Nut
14
While supporting heater, tilt the Head Assembly
3 large Flat Washers
the reflector assembly onto the Reflector Studs and slide 3 large Flat
Washers over the Reflector Studs and onto the Reflector Assembly.
Secure with 3 Wing Nuts
Nuts, return the heater to an upright position.
Hardware Used: 6x Large Flat Washer
15
Slide Cylinder Cover
Post Support . Connect the Gas Hose
to the LP cylinder. (The LP cylinder is sold separately. Use a standard
9.07 kg / 20 lb propane cylinder only.) Screw Regulator on to the Gas
Hose. Do not cross thread. Hand tighten securely then tighten with the
Wrench . Attach the Regulator to the valve on the LP cylinder and
hand tighten securely. Place LP tank onto base of heater. Secure the
LP gas tank by tightening the large bolts
base . Lower the Cylinder Cover.
NOTE: Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for storage and
handling of liquefied petroleum gas, ANSI/NFPA 58. Your local
library or fire department should have this book.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
front underneath and loosely
onto assembled Reflector
over the Reflector Studs
. Once you have tightened the Wing
3x Wing Nut
up and rest the Cylinder Cover on the
and Regulator
on the brackets
13
13
and slide
. Place
14
15
on the
13
13
14
15
9