Assembly - Fire Sense 60368 Manual

ASSEMBlY

PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list
and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble
this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBlY TIME: 60 minutes
Tools Required for Assembly (NOT included):
• Phillips screwdriver w/medium blade
*Optional Sandbox: For models that come with a sandbox, the
sandbox will be pre-assembled to the base. To fill the sandbox,
remove the 4 Large Screws and Large Nuts that secure the
base to the sandbox. Pull open the plastic cap on top of the
sandbox and fill the sandbox with water or sand. Replace the
plastic cap. Slide Base back over the sandbox and align the
holes in the base with the holes in the sandbox. Insert Large
Screws through the holes in the base and secure by tightening
Large Nuts on ends of the bolts. You may find it easier to fill the
sandbox prior to attaching wheels.
1
Attach Wheel Assembly
Wheel Assembly with corresponding holes in Base,
and insert 2 Small Bolts through the holes and finger tighten.
Be sure that the Wheel Assembly is parallel to the Base
and tighten with the Wrench.
Hardware Used: 2x Small Bolts
2
Attach the Post Supports
in the bottom of each Post Support with the hole on the
Base. Insert 1 Small Bolt through the hole in the support and
into the Base and hand tighten. Repeat with the other 2 Post
Supports and then tighten all bolts with the Wrench.
Hardware Used: 3x Small Bolts
Contact us for assistance: (866) 985-7877 | www.wtliving.com
• Leak test solution (see page 10)
K to Base J . Align holes in
I to the Base J . Align the holes
Base
Plastic Cap
J
Sandbox
5