Assembly Pages - Fire Sense LIP-10A-TGG-LPG-SP Manual

ASSEMBLY
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list and
hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble this product.
Contact customer service for replacement parts.
ESTIMATED ASSEMBLY TIME: 60 minutes
Tools Required for Assembly (NOT included): Phillips screwdriver w/medium blade, Leak Detection Solution, Adjustable wrench (2)
(Note: 10mm wrench or socket should fit M6 bolt; 13mm wrench or socket should fit M8 bolt.)
NOTE: This heater has an Electronic Ignition and will require installation of 1 – AAA battery. The battery should be installed
by unscrewing the RED IGNITER BUTTON.
1
Attach Wheels to Base
L
corresponding holes in Base, and insert 3 M6x16 Bolts
holes and finger-tighten. Repeat with second Wheel. Tighten with wrench
once both Wheels have been attached. Note: 6 - M6x16 Bolts
pre-assembled to the base. You will need to loosen and remove them to
complete this assembly.
Hardware Used: 6x Bolt M6x16
2
Attach the Post Supports
bottom of each Post Support with the hole on the Base. Insert 1
M8x16 Bolt through the hole in the support and into the Base and
M
hand tighten. Repeat with the other 2 Post Supports and then tighten
all bolts with a wrench. Note: 3 - M8x16 Bolts
to the base. You will need to loosen and remove them to complete this
assembly.
Hardware Used: 3x Bolt M8x16
Contact us for assistance: (866) 985-7877 | www.wtliving.com
. Align holes in Wheel Bracket with
K
to the Base . Align the holes in the
J K
come pre-assembled
M
through
N
come
N
1
K
N
L
L
J
M
2
N
K
5