Assembly - Fire Sense PH03-S Manual

ASSEMblY

PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package
contents list and hardware contents as listed on page 4 of this manual. If any part is missing or damaged,
do not attempt to assemble this product. Contact customer service for replacement parts.
ESTIMATED ASSEMblY TIME: 60 minutes
Tools Required for Assembly (NOT included):
• Adjustable opening wrench 8" long
Note: This heater has an Electronic Ignition and will require installation of 1 – AAA battery. The battery should be installed
by unscrewing the RED IGNITER BUTTON.
1
Unscrew the 3 Medium bolts
in to the Post Mounts
2
Use your Phillips head screwdriver to remove the
4 pre-assembled screws from base
Remove Waterbox from base, and set aside.
3
Align the 2 holes from the bracket
top of the base and insert Small bolt
the Small Washer and Small Nut
brackets. Hand tighten initially then tighten with the Wrench
when all bolts have been inserted.
Hardware Used: 3x Large Bolt, Bracket
Contact us for assistance: (866) 985-7877 | www.wtliving.com
• Phillips head screwdriver
that are pre-assembled
to the base .
and Waterbox
with the holes on
. Secure with
. Repeat with remaining 2
6x Small Bolt, Small Washer, Small Nut
• AAA Battery
.
1
2
3
5