Table of Contents
Advertisement
ASSEMBLY
PREPARATION
Before beginning assembly of this appliance, make sure all
parts and hardware are present. Compare contents with the
list on page 4. Įf any part is missing or damaged, do not
attempt to assemble the product. Contact customer service
for replacement parts.
1
Įdentify the Upper Support Posts E and Lower
Support Posts H. NOTE: Lower Support Posts have
large thread connectors at top.
Slide a Guard Bracket G onto the bottom end of
each Upper Support Post. Then screw each
Upper Support Post to a Lower Support Post.
To attach the assembled Posts to the Base K,
screw the Posts into the holes on the top of the
Base.
2
Slide the Emitter Plate C onto the pre-installed
studs on the top of the Emitter D. Fasten using 3
Nuts M6 4.
Place the emitter assembly onto the Posts as
shown by lowering the holes in the corners of the
Emitter Plate over the threads at the top of the
Posts. Fasten to the Posts using 4 Nuts M8 3.
Hardware:
3 Nut M8 x4
4 Nut M6 x3
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
Estimated assembly time: 60 minutes
Required for assembly (not included):
• Phillips screwdriver w/ medium blade
• Adjustable crescent wrench
• AAA battery (for ignition)
• Leak-test solution (see operation
instructions)
E
G
H
Large
threads
4
C
D
K
3
5
Advertisement
Table of Contents
