Table of Contents
Advertisement
ASSEMBLY
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents
list and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to
assemble this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBl Y TIME: 60 minutes
Tools Required for Assembly (NOT included):
• 7/16" open-end wrench
• Adjustable opening wrench
Note: This heater has an Electronic Ignition and will require installation of 1 – AA battery. Install the
battery by unscrewing the RED IGNITER BUTTON. Battery not included.
1
Attach Wheel Assembly
holes in Wheel Assembly with corresponding holes in base
and insert 2pcs M8x16 Bolt
bolts. Be sure that the Wheel Assembly is parallel to base and
fully tighten the bolts.
Hardware Used: 2x M8x16 Bolt
2
Attach the Cylinder Bracket
Assembly
with the 3 - M8x12 Bolts
E
Nuts
that are pre-assembled in the Cylinder Bracket
N
the M8x45 Bolt
O
(pre-assembled in the Cylinder Bracket) to
secure the LP gas cylinder in place once it has been placed on
the base inside the Tank Assembly
Hardware Used: 3x M8x12 Bolt
Contact us for assistance: (866) 985-7877 | www.wtliving.com
• Philips screwdriver with medium blade
• Leak Test Solution (see instructions on page 9 on how to make solution.)
F
to Tank Assembly
E
. Line up
G
through holes. Finger tighten
L
to base of the Tank
and 3 - M8
M
E
.
3x M8 Nut
3x M8x45 Bolt
. Use
L
2
G
F
L
M
M
M
O
O
N
N
E
O
5
Hide quick links:
Advertisement
Table of Contents
