Air Filter; Engine Coolant - Can-Am Spyder RT Operator's Manual

Air Filter

Air Filter Removal
1. Remove the following body pan-
els to access the air filter. Refer to
BODY PANELS
subsection.
– LH side panel.
– LH top side panel.
Remove the 3 screws from the air filter
cover.
rmo2014-005-016_a
1. Cover
2. Screws
Remove the air filter cover and the fil-
ter.
rmo2014-005-026_a
1. Cover
2. Filter
EQUIPMENT
in the
______________
MAINTENANCE PROCEDURES
Air Filter Inspection
Inspect air filter for cleanliness and
damage.
NOTICE
It is not recommended to
blow compressed air on the paper
filter. This could damage the paper
fibers and reduce its filtration ability
when used in dusty environments.
NOTICE
Do not wash the paper fil-
ter with any cleaning solution.
Replace air filter as necessary.
Air Filter Installation
Carefully install air filter into position.
NOTE: The air filter should sit it-
self correctly. Please make sure the
seat/receptacle of the intake hose is
not deformed before inserting the air
filter.
Properly position air filter cover then
secure with all screws.
TIGHTENING TORQUE
Air filter cover
screws
Reinstall parts in the reverse order of
their removal.

Engine Coolant

Engine Coolant Level Verification
WARNING
When opening the reservoir, the
coolant can be very hot and spray
out if the engine is hot. In order
to avoid getting burned, check the
coolant level when the engine is
cold.
The cooling system must be filled with
distilled water and antifreeze solution
(50% distilled water, 50% antifreeze).
2.5 N•m to 3 N•m
(22 lbf•in to 27 lbf•in)
127