Table of Contents
Advertisement
rmr2014-011-302_a
TYPICAL - SM6 MODEL SHOWN
1. Engine oil drain plug
6. Remove the dipstick.
7. Allow sufficient time for oil to com-
pletely drain.
8. Clean area around magnetic drain
plug in the clutch cover.
9. Place an appropriate drain pan under
the clutch cover.
10. Remove the magnetic oil drain
plug and discard the sealing ring.
rmr2014-011-301_a
TYPICAL - SE6 MODEL SHOWN
1. Clutch cover magnetic drain plug
Replace engine oil filter. Refer to
GINE OIL FILTER REMOVAL
this section.
11. Allow sufficient time for oil to com-
pletely drain from clutch cover.
12. Check and clean oil filter cavity for
dirt and contamination.
13. Clean the magnet on the magnetic
drain plug.
14. Using NEW sealing washers and
NOTICE
plug sealing washers and O-rings.
Always replace it with a new one.
15. Tighten drain plugs as specified.
Tightening torque
MAGNETIC DRAIN PLUG (CLUTCH
Tightening torque
Reinstall engine oil filter. Refer to
GINE OIL FILTER INSTALLATION
16. Pour following amount of the rec-
MODEL
EN-
further in
SM6
______________
MAINTENANCE PROCEDURES
O-rings and install both drain plugs.
Never reuse the drain
DRAIN PLUG (OIL SUMP COVER)
Sealing ring
O-rings
COVER)
Sealing ring
ommended oil into the oil tank.
OIL QUANTITIES
Engine oil
and engine
oil filter
replacement
Engine oil,
SE6
engine
oil filter
and HCM
surface
filter
replacement
Engine oil
and engine
oil filter
replacement
NEW
NEW
28 N•m ± 2 N•m
(21 lbf•ft ± 1 lbf•ft)
NEW
20 N•m ± 1 N•m
(15 lbf•ft ± 1 lbf•ft)
EN-
.
QUANTITY
4.7 L
(5 qt (U.S. liq.))
4.9 L
(5.2 qt (U.S. liq.))
4.5 L
(4.8 qt (U.S. liq.))
125
Advertisement
Table of Contents
