Table of Contents
Advertisement
MAINTENANCE PROCEDURES
– Brake discs for excessive wear and
surface condition
– Brake pads for wear, damage or
looseness.
RT-S and RT LTD SE6 Models
1. Release the latch underneath the
floorboard.
2. Pivot the floorboard by manually
pushing down its front part.
3. Flip back the floorboard until it
latches.
The mechanism must
work freely.
See an authorized Can-Am roadster
dealer if there are any problems with
the brake system.
Headlights and Fog Lights
Headlights Aiming Verification
(North American Models)
1. Verify tires are correctly inflated.
SPECIFICATIONS
Refer to
2. Set the rear suspension air pressure
to 0 kPa (0 PSI) using the schrader
valve located under the seat.
rmo2010-001-056_a
1. Schrader valve
3. Position vehicle in front of a test sur-
face as shown. Make sure vehicle is
on leveled ground.
______________
136
rmo2010-001-007_b
A. 10 m (33 ft)
rmo2010-001-008_a
Trace 2 lines parallel to the ground on
the test surface as follows:
.
4. Select low beam.
5. Beam aiming is correct when the
rbl2015-005-005_a
TYPICAL HEADLIGHT REFLECTION ON TEST
SURFACE (BOTH HEADLIGHTS)
1. Ground
2. Top line
A. 703 mm (27-11/16 in)
B. 773 mm (30-7/16 in)
90°
LINES ON THE TEST SURFACE
703 mm (27-11/16 in)
Line A
773 mm (30-7/16 in)
Line B
top line of the headlight reflection is
between lines A and B.
above ground
above ground
2
1
A B
Advertisement
Table of Contents
