Table of Contents
Advertisement
3. Check the brake fluid level in both
reservoirs, near the back of the seat.
They should both be above the MIN.
mark.
rmo2010-001-091_a
1. Brake fluid MAX. level mark
2. Brake fluid MIN. level mark
rmo2010-001-092_a
A. Operating range
4. Add fluid as required. Refer to
ADDING BRAKE FLUID
NOTE: Low brake fluid may indicate
leaks or worn brake pads. See an au-
thorized Can-Am roadster dealer.
Adding Brake Fluid
Remove the filler cap.
WARNING
Clean filler cap before removing.
Use only DOT 4 brake fluid from a
sealed container.
1. Add fluid to MAX level.
NOTICE
Brake fluid can damage
painted surfaces or plastic parts.
Wipe up any spills.
2. Reinstall filler cap as follows:
TYPICAL
1. V slit
TYPICAL
1. Correct position
2. Wrong position
subsection.
3. Close the seat and ensure it is fully
Brake System Verification
The front and rear brakes are hy-
draulic disc types. These brakes are
self-adjusting and do not require ad-
justment.
The brake pedal also requires no ad-
justment.
To keep brakes in good condition,
check the following as per the
TENANCE SCHEDULE
– Entire brake system for fluid leaks
– Brake pedal for spongy feel
______________
MAINTENANCE PROCEDURES
2.1 Check that V slit is in good con-
dition.
2.2 Ensure diaphragm are prop-
erly positioned.
rbg2008-003-002_a
vmr2008-033-062_a
latched.
MAIN-
:
135
Advertisement
Table of Contents
