Lighting Instructions - Valor 1100IN Danger A Barrier Designed To Reduce The Risk Of Burns From The Hot Viewing Glass Is Provided With Th

H5 series

Hide thumbs Also See for 1100IN:

Installation & owner's manual (72 pages)

Table Of Contents

Table of Contents

WARNING: If you do not follow these instructions exactly, a ﬁ re or explosion may result

causing property damage, personal injury or loss of life.

A. This appliance has a pilot which must be lighted by hand, remote control, or wall switch. Follow these instructions

exactly. To save gas, turn the pilot off when not using the appliance for a prolonged period of time.

B. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the ﬂ oor because

some gases are heavier than air and will settle on the ﬂ oor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the ﬁ re department.

C. Use only your hand to push in or turn the control knobs. Never use tools. If the knobs will not push in or turn by

hand, don't try to repair them; call a qualiﬁ ed service technician. Force or attempted repair may result in a ﬁ re or

explosion.

D. Do not use this appliance if any part has been under water. Immediately call a qualiﬁ ed service technician to

inspect the appliance and to replace any part of the control system and any gas control, which has been under water.

1. STOP! Read the safety information above.

2. TO CLEAR ANY GAS, turn main valve off by pressing the

• Wait ﬁ ve (5) minutes to clear out any gas, then smell for gas, including near the ﬂ oor. If you

smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell

gas, go to the next step.

3. AUTOMATIC IGNITION: MAN-knob (2) in ON position. Ensure Flame Adjustment

knob (3) is set to lowest setting () (Fig. 1). Locate the pilot (Fig. 3.) inside the

ﬁ rebox.

• On the remote control handset, press the

conﬁ rms the start has begun.

• Further short acoustic signals indicate the ignition process is in progress.

• When the pilot is lit, the Flame Adjustment knob (3) will automatically rotate to

the highest setting.

• Press the

button on the remote control handset to reduce the ﬂ ame height.

4. MANUAL IGNITION: MAN-knob (2) in MAN position (Fig. 2). With the window

off, locate the pilot (Fig. 3) inside the ﬁ rebox.

• Set Flame Adjustment knob (3) to the lowest setting ().

• Push down the metallic core (4) with a pen or similar instrument; this will establish

the pilot gas ﬂ ow.

• Light gas at the pilot (5) with a match.

• Continue holding down metal core (4) for about 10 seconds; after release, pilot

should remain lit.

•

If the pilot will not stay lit after several tries, turn the gas control knob (3) to OFF () and call your local

service technician or gas supplier.

• Reinstall the window and set the MAN-knob (2) to ON; turn Flame Adjustment knob (3) up () or down ()

manually or use the

AUTOMATIC SHUT-OFF (using the remote control handset):

• Press and hold the

• Press the

button on remote handset to shut-off the appliance, including pilot ﬂ ame.