Section 6 − Advanced Functions; Programable Tig Start Parameters - Miller DYNASTY 200 DX Owner's Manual

SECTION 6 − ADVANCED FUNCTIONS
NOTE

6-1. Programable TIG Start Parameters

Accessing Programmable TIG Start Parameters
A.
4
5 1
NOTE: The welding cycle can be execut-
ed while in programmable start mode.
Before accessing programmable TIG
Start Polarity, Amperage, and Time
modes, be sure that all procedures and
parameters are established.
1 Process Switch Pad
2 Amperage Switch Pad
3 Power Switch
To access the programmable TIG Start
Amperage and Time screens, turn power
on, and then press the Process and Am-
perage switch pads before the software
version clears the meters. Hold switch
Section 6 in this manual covers operation of all models of 200 and 300 ampere
inverter based TIG machines. Features and options referenced may not be
available on your machine. Verify the model you have before using this section.
6
And
pads until software version clears the
meters and [SEL] [EP] or [SEL] [EN] appears.
4 Memory Switch Pad (If Equipped)
Press Memory switch pad to select de-
sired memory location (see Section
5-14).
5 Polarity Switch Pad (If Equipped)
Press Polarity switch pad to select AC or
DC (see Section 5-6).
Note: Each memory location and each
polarity (AC or DC) has its own set of start
parameters.
2
Or
Or
V
Rear Panel
Press the Process switch pad to select
the desired process, TIG HF Impulse or
TIG Lift Arc, for your application (see
Section 5-7). The parameter values are
the same for both processes, and any
changes made to the values in one pro-
cess, are duplicated in the other process.
6 Output Switch Pad
Press Output switch pad to select de-
sired type of control (see Section 5-8).
Proceed to Section B, C and/or D.
To save changes and exit Advanced
Functions, turn power off.
Or
3
OM-2240 Page 35