Miller DYNASTY 200 DX Owner's Manual page 46

C. Reconfiguring RMT 2T HOLD For 2T, 3T, Spot, 4T, 4T Momentary, Or Mini Logic Control
1
For RMT STD (Remote Standard), RMT
2T Hold (Remote 2T Hold), and On trig-
ger operation, see Section 6-2A, B, and
H.
1 Process Switch Pad
2 Output Switch Pad
3 Power Switch
OM-2240 Page 40
SEL
2
And
To access the RMT 2T HOLD reconfi-
guration screen, turn power switch on
and then press the Process and Output
switch pads before the software version
clears the meters. Hold the switch pads
until software version clears the meters
and [SEL] [H-2], [SEL] [SPO], [SEL] [H-4], [SEL]
[H4L], (SEL) (H-3), or [SEL] [H4E] appears.
4 Encoder Control
Turn Encoder to change functions. Ac-
tive function will be displayed on amper-
age (right) meter.
4
H−2
Or
V
Rear Panel
5 Meter Displays
Meter displays for the different functions
will be as shown.
Press torch trigger or turn power Off to
save setting.
NOTE: After 2T has been reconfigured
and one of the reconfigured functions is
selected during normal operation, H−4,
H4L, H4E, H-3, or SPO will be displayed for 1
second as a reminder to the operator.
Or Or
3