Encoder Control; Amperage Control; Ammeter And Parameter Display - Miller DYNASTY 200 DX Owner's Manual

5-2. Encoder Control

5-3. Amperage Control

5-4. Ammeter And Parameter Display

OM-2240 Page 24
1
3
1
Or
1
1 Encoder Control
Use control in conjunction with ap-
plicable front panel function switch
pad to set values for that function.
1 A (Amperage Control)
2 Encoder Control
3 Ammeter
See Section 5-16 for Amperage
2
control range.
Press Amperage switch pad and
turn Encoder control to set weld
amperage. Weld amperage setting
is also peak amperage when Pulser
function is active (see Section 5-9).
Or
1 Ammeter
Displays actual amperage while
welding. Meter also displays preset
parameters for any of the following
units of measure when they are ac-
tive: amperage, time, percentage or
frequency.
LED, located directly below the am-
meter, will also illuminate.
The corresponding